Current File : //lib/modules/2.6.32-754.30.2.el6.x86_64/build/arch/x86/include/asm/pgtable-3level.h
#ifndef _ASM_X86_PGTABLE_3LEVEL_H
#define _ASM_X86_PGTABLE_3LEVEL_H
/*
* Intel Physical Address Extension (PAE) Mode - three-level page
* tables on PPro+ CPUs.
*
* Copyright (C) 1999 Ingo Molnar <mingo@redhat.com>
*/
#define pte_ERROR(e) \
printk("%s:%d: bad pte %p(%08lx%08lx).\n", \
__FILE__, __LINE__, &(e), (e).pte_high, (e).pte_low)
#define pmd_ERROR(e) \
printk("%s:%d: bad pmd %p(%016Lx).\n", \
__FILE__, __LINE__, &(e), pmd_val(e))
#define pgd_ERROR(e) \
printk("%s:%d: bad pgd %p(%016Lx).\n", \
__FILE__, __LINE__, &(e), pgd_val(e))
/* Rules for using set_pte: the pte being assigned *must* be
* either not present or in a state where the hardware will
* not attempt to update the pte. In places where this is
* not possible, use pte_get_and_clear to obtain the old pte
* value and then use set_pte to update it. -ben
*/
static inline void native_set_pte(pte_t *ptep, pte_t pte)
{
mm_track_pte(ptep);
ptep->pte_high = pte.pte_high;
smp_wmb();
ptep->pte_low = pte.pte_low;
}
#define __HAVE_ARCH_READ_PMD_ATOMIC
/*
* pte_offset_map_lock on 32bit PAE kernels was reading the pmd_t with
* a "*pmdp" dereference done by gcc. Problem is, in certain places
* where pte_offset_map_lock is called, concurrent page faults are
* allowed, if the mmap_sem is hold for reading. An example is mincore
* vs page faults vs MADV_DONTNEED. On the page fault side
* pmd_populate rightfully does a set_64bit, but if we're reading the
* pmd_t with a "*pmdp" on the mincore side, a SMP race can happen
* because gcc will not read the 64bit of the pmd atomically. To fix
* this all places running pmd_offset_map_lock() while holding the
* mmap_sem in read mode, shall read the pmdp pointer using this
* function to know if the pmd is null nor not, and in turn to know if
* they can run pmd_offset_map_lock or pmd_trans_huge or other pmd
* operations.
*
* Without THP if the mmap_sem is hold for reading, the
* pmd can only transition from null to not null while read_pmd_atomic runs.
* So there's no need of literally reading it atomically.
*
* With THP if the mmap_sem is hold for reading, the pmd can become
* THP or null or point to a pte (and in turn become "stable") at any
* time under read_pmd_atomic, so it's mandatory to read it atomically
* with cmpxchg8b.
*/
#ifndef CONFIG_TRANSPARENT_HUGEPAGE
static inline pmd_t read_pmd_atomic(pmd_t *pmdp)
{
pmdval_t ret;
u32 *tmp = (u32 *)pmdp;
ret = (pmdval_t) (*tmp);
if (ret) {
/*
* If the low part is null, we must not read the high part
* or we can end up with a partial pmd.
*/
smp_rmb();
ret |= ((pmdval_t)*(tmp + 1)) << 32;
}
return (pmd_t) { ret };
}
#else /* CONFIG_TRANSPARENT_HUGEPAGE */
static inline pmd_t read_pmd_atomic(pmd_t *pmdp)
{
pmdval_t val = (pmdval_t)atomic64_read((atomic64_t *)pmdp);
return (pmd_t) { val };
}
#endif /* CONFIG_TRANSPARENT_HUGEPAGE */
static inline void native_set_pte_atomic(pte_t *ptep, pte_t pte)
{
mm_track_pte(ptep);
set_64bit((unsigned long long *)(ptep), native_pte_val(pte));
}
static inline void native_set_pmd(pmd_t *pmdp, pmd_t pmd)
{
mm_track_pmd(pmdp);
set_64bit((unsigned long long *)(pmdp), native_pmd_val(pmd));
}
/*
* PHYSICAL_PAGE_MASK is casted to 32 bits, so we can't use it here.
*/
#define PGD_PAE_PHYS_MASK (__PHYSICAL_MASK & PAGE_MASK)
/*
* PAE allows Base Address, P, PWT, PCD and AVL bits to be set in PGD entries.
* Bits 9-11 are ignored. All other bits are Reserved (must be zero).
*/
#define PGD_ALLOWED_BITS (PGD_PAE_PHYS_MASK | _PAGE_PRESENT | \
_PAGE_PWT | _PAGE_PCD | \
_PAGE_UNUSED1 | _PAGE_IOMAP | _PAGE_HIDDEN)
static inline void native_set_pud(pud_t *pudp, pud_t pud)
{
mm_track_pud(pudp);
#ifdef CONFIG_PAGE_TABLE_ISOLATION
pud.pgd.pgd &= PGD_ALLOWED_BITS;
pud.pgd = pti_set_user_pgd((pgd_t *)pudp, pud.pgd);
#endif
set_64bit((unsigned long long *)(pudp), native_pud_val(pud));
}
#ifdef CONFIG_PAGE_TABLE_ISOLATION
/*
* The NX bit isn't allowed in the PDPTE (PGD) entries in Physical Address
* Extension (PAE) mode. As a result, PGD entry poisoning for user PGD
* entries won't work.
*/
static inline void kaiser_poison_pgd(pgd_t *pgd)
{
}
static inline void kaiser_unpoison_pgd(pgd_t *pgd)
{
}
static inline void kaiser_poison_pgd_atomic(pgd_t *pgd)
{
}
static inline void kaiser_unpoison_pgd_atomic(pgd_t *pgd)
{
}
#endif
/*
* For PTEs and PDEs, we must clear the P-bit first when clearing a page table
* entry, so clear the bottom half first and enforce ordering with a compiler
* barrier.
*/
static inline void native_pte_clear(struct mm_struct *mm, unsigned long addr,
pte_t *ptep)
{
mm_track_pte(ptep);
ptep->pte_low = 0;
smp_wmb();
ptep->pte_high = 0;
}
static inline void native_pmd_clear(pmd_t *pmd)
{
u32 *tmp = (u32 *)pmd;
mm_track_pmd(pmd);
*tmp = 0;
smp_wmb();
*(tmp + 1) = 0;
}
static inline void pud_clear(pud_t *pudp)
{
mm_track_pud(pudp);
set_pud(pudp, __pud(0));
#ifdef CONFIG_PAGE_TABLE_ISOLATION
pti_set_user_pgd((pgd_t *)pudp, __pgd(0));
#endif
/*
* According to Intel App note "TLBs, Paging-Structure Caches,
* and Their Invalidation", April 2007, document 317080-001,
* section 8.1: in PAE mode we explicitly have to flush the
* TLB via cr3 if the top-level pgd is changed...
*
* Currently all places where pud_clear() is called either have
* flush_tlb_mm() followed or don't need TLB flush (x86_64 code or
* pud_clear_bad()), so we don't need TLB flush here.
*/
}
#ifdef CONFIG_SMP
static inline pte_t native_ptep_get_and_clear(pte_t *ptep)
{
pte_t res;
mm_track_pte(ptep);
/* xchg acts as a barrier before the setting of the high bits */
res.pte_low = xchg(&ptep->pte_low, 0);
res.pte_high = ptep->pte_high;
ptep->pte_high = 0;
return res;
}
#else
#define native_ptep_get_and_clear(xp) native_local_ptep_get_and_clear(xp)
#endif
/*
* Bits 0, 6 and 7 are taken in the low part of the pte.
* The 32 bits of offset is split into both the lower and upper 32 bits
* of the pte as follows:
*
* Bits 0-08: _PAGE_FILE
* Bits 9-24: low 16 bits of the offset
* Bits 25-31: 1s
* --------------
* Bits 32-47: 1s
* Bits 48-63: high 16 bits of the offset
*
* So unless the system has more than (MAX-PA - 32M) of memory, the offset
* entry won't match any of the physical memory addresses.
*/
#define _PGOFF_ENTRY_SHIFT 9
#define _PGOFF_HI16_MASK 0xffff0000
#define _PGOFF_LO16_MASK 0x0000ffff
#define pte_to_pgoff(pte) \
(((pte).pte_high & _PGOFF_HI16_MASK) | \
(((pte).pte_low >>_PGOFF_ENTRY_SHIFT) & _PGOFF_LO16_MASK))
#define pgoff_to_pte(off) ((pte_t) { { \
.pte_low = _PAGE_FILE | \
(((off) | _PGOFF_HI16_MASK) << _PGOFF_ENTRY_SHIFT), \
.pte_high = (off) | _PGOFF_LO16_MASK } })
#define PTE_FILE_MAX_BITS 32
/*
* Encode and de-code a swap entry
*
* With a maximum supported physical address bit size of 46, there are 18
* high order bits available. So we can split the 32-bit swap entry into 2
* 16-bit halves and put them into the high and low 32-bit words of the PTE
* as follows:
*
* bits 0-08: 0s
* bits 9-24: low 16 bits of swap entry
* bits 25-31: 1s
* --------------
* bits 32-47: 1s
* bits 48-63: high 16 bits of swap entry
*
* So unless the system has more than (MAX-PA - 32M) of memory, the swap
* entry won't match any of the physical memory addresses.
*/
#define MAX_SWAPFILES_CHECK() BUILD_BUG_ON(MAX_SWAPFILES_SHIFT > 5)
#define __swp_type(x) (((x).val) & 0x1f)
#define __swp_offset(x) ((x).val >> 5)
#define __swp_entry(type, offset) ((swp_entry_t){(type) | (offset) << 5})
#define _PTE_SWAP_ENTRY_SHIFT 9
#define _SWAP_HI16_MASK 0xffff0000
#define _SWAP_LO16_MASK 0x0000ffff
#define __pte_to_swp_entry(pte) ((swp_entry_t) { \
((pte).pte_high & _SWAP_HI16_MASK) | \
(((pte).pte_low >> _PTE_SWAP_ENTRY_SHIFT) & _SWAP_LO16_MASK) })
#define __swp_entry_to_pte(x) ((pte_t) { { \
.pte_high = (x).val | _SWAP_LO16_MASK, \
.pte_low = ((x).val | _SWAP_HI16_MASK) << _PTE_SWAP_ENTRY_SHIFT } })
#include <asm/pgtable-invert.h>
#endif /* _ASM_X86_PGTABLE_3LEVEL_H */
Mini Shell